Fetched and shutdown time can be seen as restrictive by administration, but catching  a issue in its earliest stages can spare time and money within the long run. Whereas it  could seem as well troublesome to do a comprehensive review, a basic visual  assessment of gear contact designs through an review harbour can avoid future  disastrous disappointments. In the event that in-house assessment mastery isn't  accessible, an master can be enlisted to perform the review and prepare personnel. 


Overcoming imperatives in arrange to permit an review can offer assistance to amplify  gearbox life and maintain a strategic distance from disastrous disappointment. 


This  might too spare time, cash, harm to work force and harm to adjoining equipment.  This article portrays the gear and strategies fundamental to perform an on-site gearbox  inspection. 


Getting Prepared: Good Housekeeping is Essential Before beginning an inspection,  prepare an inspection form for documenting your observations. It should be designed  for your specific application. Next, assemble the necessary equipment. 


There are several sources of gearbox contamination, including those that are built-in,  internally generated, ingressed, and added during maintenance. Many gearboxes  operate in dirty environments. Therefore, good housekeeping methods should be used  during inspections. Areas around inspection ports and other openings should be  cleaned before they are opened. Inspectors should take care not to drop anything into  the gear- box. Shirt pockets should be empty and tools should be stored in a tool belt.  Ports should never be left open during breaks and should be closed and secured after  the inspection is complete. 


Walk-around visual inspection. You should perform a thorough external examination  before the gearbox inspection port is opened. Use an inspection form to record  important data that would otherwise be lost once cleaning is completed. For example,  before cleaning the exterior of the gear housing, inspect it for signs of overheating, corrosion, contamination, oil leaks and damage. Measure the tightening torque of  structural fasteners that carry significant loads, such as torque arm bolts. Look for  evidence of movement, including cracked paint or fretting corrosion at structural  interfaces. Note the condition of the fasteners and inspect load-bearing surfaces of components for fretting corrosion or other evidence ofmovement.


The following are signs of overheating

? Discolored or burnt paint on housings 

? Water sprayed on the housing or shafts evaporates quickly, boils or crackles 

? Temper colors on unpainted surfaces 

? Melted plastic components, such as shipping plugs 

? Low oil level in sight glass or on dipstick 

? Dark oil in sight glass or on dipstick 

? Foam in sight glass 

? Waterin sight glass orsludge on filter element (may indicate oil cooler failure) 

? Metal chips on magnetic plugs, chip detectors or filters (may denote gear or bearing failure caused by overheating) 

? Smoke from shafts, seals or breathers


image

Previous: Lubricant Traction Effect On Wormgear Efficiency

Next: Gear Shaft Manufacturing Analysis

[[Related News]]

Related Products

国产三级

<strike id="ziafn"></strike>
  • <font id="ziafn"><b id="ziafn"><button id="ziafn"></button></b></font>

    <td id="ziafn"></td>

        <th id="ziafn"><menu id="ziafn"></menu></th>